If I draw a spline and then explode it, is there any way to offset that path?
I tried with parallel lines, but it is a very long task!
Offset
Moderator: andrew
Re: Offset
Hi Andrew,
i tried to follow your steps. I had a spline, exploded it ( had to do it twice actually) and tried to combine the segements. But i got an error saying:"Element is no line or arc".
What did i do wrong?
i tried to follow your steps. I had a spline, exploded it ( had to do it twice actually) and tried to combine the segements. But i got an error saying:"Element is no line or arc".
What did i do wrong?
Re: Offset
OK, found it out:
after the first "explode"-command the spline was already a polyline. It was then already possible to offset the line with the command equidistance.
after the first "explode"-command the spline was already a polyline. It was then already possible to offset the line with the command equidistance.