Page 1 of 1

Intersecting Lines

Posted: Wed Jun 18, 2008 5:24 am
by tchiz
How do I draw intersecting lines that are not supposed to touch each other? As in a wire diagram, where two wires cross, but are not supposed to touch each other.

Posted: Wed Jun 18, 2008 9:57 am
by andrew
Is this a question about dxflib or QCad?

Intersecting Lines

Posted: Wed Jun 18, 2008 10:36 pm
by tchiz
It is about QCAD

Re: Intersecting Lines

Posted: Wed Jun 18, 2008 11:00 pm
by andrew
tchiz wrote:It is about QCAD
OK - please post your question again in one of the QCad forums if you don't mind. This is a dxflib forum.

You can find the overview over the forums here:
http://www.ribbonsoft.com/rsforum/

Thanks