Page 1 of 1

Legend in Printouts?

Posted: Tue Nov 19, 2013 11:58 am
by rrauch
Hi Everyone,

I am planning to buy a CAD Software. I found QCAD, because it has good recommendations on different sites.

We started now with QCAD Trial and have made some very first drawings. There are a few things, we do not know, how to do. Either it is not supported from QCAD or we do not know, how to do:

1. Is there any possibility to generate a "Legend" in the print outs? With a legend I mean such typical block at the lower right corner with information about company, date, version, title, page number and so on....

For next question I will create specific forum thread....

Thanks in Advance

Re: Legend in Printouts?

Posted: Tue Nov 19, 2013 12:22 pm
by Clive
rrauch wrote:1. Is there any possibility to generate a "Legend" in the print outs? With a legend I mean such typical block at the lower right corner with information about company, date, version, title, page number and so on....
Hi rrauch and welcome.
Of course you can create your own blocks (legend) but currently you cannot 'dynamically' generate them, you can also define and synchronize block attributes, which may help.
Andrews screencast explains more:
viewtopic.php?f=47&t=2563

Re: Legend in Printouts?

Posted: Tue Nov 19, 2013 1:58 pm
by rrauch
ok, I see. Thanks a lot.

Maybe this idea is of common interest: I created suggestion in "QCAD 3 Suggestions and Feedback" : viewtopic.php?f=31&t=2670