Hi all,
Is there a setting you can apply to a drawing that will automatically turn any rectangle you draw into a polyline rather than four separate lines
Jules
Setting for creating rectangle
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Re: Setting for creating rectangle
Hello Jules,
But - you can use the "Create from Segments" tool (below Draw, Polyline). Much faster than the single segment selection.
No, not that I know.JulesB wrote:Is there a setting you can apply to a drawing that will automatically turn any rectangle you draw into a polyline rather than four separate lines
But - you can use the "Create from Segments" tool (below Draw, Polyline). Much faster than the single segment selection.
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Re: Setting for creating rectangle
Hi Jules
If you are creating Rectangles using the 'Shape Tools' there is a check-box you can tick to 'Create Polyline' from all the rectangles you draw using this tool!
If you are creating Rectangles using the 'Shape Tools' there is a check-box you can tick to 'Create Polyline' from all the rectangles you draw using this tool!
For the best support please state your operating system, QCAD version and add any supporting DXF/DWG files, screenshots etc...
Re: Setting for creating rectangle
Thanks for your replies guys, much appreciated
Clive could you clarify where you find shape tools... is it under the draw menu?
Clive could you clarify where you find shape tools... is it under the draw menu?
Re: Setting for creating rectangle
Here we go -JulesB wrote:Clive could you clarify where you find shape tools... is it under the draw menu?
Yes Draw > Shape
For the best support please state your operating system, QCAD version and add any supporting DXF/DWG files, screenshots etc...
Re: Setting for creating rectangle
Thank you Clive, sorry I didn't see it for some reason