aligning holes

[aklweld]

Hi
im having a bit of trouble drawing the holes I need on the attached part, I have been able to do the vertical and horizontal ones but I cant figure out how put the holes on the angled section of the job, the need to be running parallel with the sides 25mm in, if someone could tell me how/or what function I should be using I would be very grateful

I have attached the file and also I have attached a photo of the physical template im working off.

Any comments or suggestions would be greatly appreciated.

Cheers
Matt

A1.jpg (563.55 KiB) Viewed 3519 times

[Husky]

Hello Matt - welcome to the forum!

Hi
im having a bit of trouble drawing the holes I need on the attached part, I have been able to do the vertical and horizontal ones but I cant figure out how put the holes on the angled section of the job, the need to be running parallel with the sides 25mm in, if someone could tell me how/or what function I should be using I would be very grateful ...

For the 25 mm offset I would use the Modify tool "Offset with distance",

Husky-2015.09.01-03.png (68.8 KiB) Viewed 3516 times

Then I would copy one hole (circle) to the clipboard what brings me into the position to use the "Paste along entity" tool.

Husky-2015.09.01-02.png (68.32 KiB) Viewed 3516 times

What do you think - will that help?

[aklweld]

that was exactly what I needed, thanks husky

cheers
matt