Hello,
I cannot trim/lengthen any polylines. Lines with 2 Points work with these two commands. I think it is similar to this topic viewtopic.php?f=33&t=2775
Systeminfo:
openSuse 13.1 (64bit)
QCAD Version: 3.6.0.0 (3.6.0)
Thanks
[SOLVED] Trim/Lenghten Polyline Not working
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
[SOLVED] Trim/Lenghten Polyline Not working
- Attachments
-
- PolyLine_Lengthen_Problem.dxf
- Polyline trim/lengthen problem example
- (124.02 KiB) Downloaded 407 times
Last edited by pbergaus on Sun Jun 22, 2014 7:59 pm, edited 1 time in total.
QCad: 3.9.1
Linux Mint: 17.1. Rebecca
Linux Mint: 17.1. Rebecca
Re: Trim/Lenghten Polyline Not working
Hello,
QCAD doesn't offers a trim tool for polylines.
See the description for the Trim tool:
Trim
Description:
Trims or extends a line, arc or ellipse to another entity
But there is a kind of workaround to solve your problem.
Select the polyline and use the blue Anker to extent to the other polyline. The snap to get it done precisely is "Intersection manual".
Check this out:
QCAD doesn't offers a trim tool for polylines.
See the description for the Trim tool:
Trim
Description:
Trims or extends a line, arc or ellipse to another entity
But there is a kind of workaround to solve your problem.
Select the polyline and use the blue Anker to extent to the other polyline. The snap to get it done precisely is "Intersection manual".
Check this out:
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Re: Trim/Lenghten Polyline Not working
Hello,
thank you for the workaround.
Will the trim/lengthen tool work with polylines in the future? Or is it not intended to work with a polyline because of different problems of that type of line?
At the office I work with AutoCad and so I am used to use polylines primarily.
Thank you
pbergaus
thank you for the workaround.
Will the trim/lengthen tool work with polylines in the future? Or is it not intended to work with a polyline because of different problems of that type of line?
At the office I work with AutoCad and so I am used to use polylines primarily.
Thank you
pbergaus
QCad: 3.9.1
Linux Mint: 17.1. Rebecca
Linux Mint: 17.1. Rebecca