Hi,
I was using librecad and i switched to qcad. When i try to save my file i get such kind of message:
File format is not good: R15 2000 dxg trawing teigha
And then other notes mentioning that there will be positive/negative issues...
So i should change format, but when i want to save a file, the only format possible is "R15 2000 dxg trawing teigha".
How to get the proper format? And which format is the good one ?
how to select the proper format
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Re: how to select the proper format
I forgot to give the version of my qcad:
3.12.0.0 (3.12.0)
3.12.0.0 (3.12.0)
Re: how to select the proper format
I just installed qcad on the computer of my work. I opened the job done at home, saved it, and it saves it into the format : R27. And it does not give any error message.
At my job i have the same version of qcad : 3.12.1.0 (3.12.1)
Also, (at my job) i can save it in any format. Why can't i do that home ???
At my job i have the same version of qcad : 3.12.1.0 (3.12.1)
Also, (at my job) i can save it in any format. Why can't i do that home ???
Re: how to select the proper format
Is this QCAD Professional, a QCAD Professional Trial version or the QCAD Community Edition? Thanks.