Question about the Isometric tool ...

Drop in here to discuss whatever you want.

Moderator: andrew

Question about the Isometric tool ...

Postby Husky » Fri Jan 11, 2013 3:43 am

If I use the Isometric tool my Projection is scaled:
20" comes to 16 21/64
I was expecting a 1:1 projection? Why isn't it 1:1?

Any chance to get a Dimetrie Projection in QCAD what is more common in the "Engineer world".
(Ratio 0,5[x]: 1 : 1, Angle 7°/42°)
User avatar
Husky
Moderator
 
Posts: 690
Joined: Wed May 11, 2011 9:25 am
Location: USA

Re: Question about the Isometric tool ...

Postby andrew » Fri Jan 11, 2013 11:19 am

Please allow me to quote the book "QCAD - An Introduction to Computer- Aided Design (CAD)" page 234:

"The Scale of Isometric Projections

One of the advantages of isometric projections compared to other three-dimensional projections is that the scale along all three axes of the Cartesian coordinate system is identical. If a cube is projected, all edges have the same length in the isometric projection. However, the length in the projection is not identical to the real length or original length as shown in the orthogonal projection. The projected lengths in an isometric projection are about 0.81647 times the true length. The exact scale factor can be calculated as the cosine of 35 degrees and 16 minutes.

Traditionally, isometric projections are often scaled 1:1 because they are easier to produce in real scale. An isometric projection that is scaled to 100% of the true scale is called an Isometric Drawing. With QCAD, you can produce an isometric drawing by scaling the isometric projection with a factor of 1.224779 or 1 / cos(35°16')."


Note: QCAD >3.0 will have an option for "True scale" (as opposed to "True projection" as default). "True scale" produces a traditional isometric drawing.
User avatar
andrew
Site Admin
 
Posts: 2661
Joined: Fri Mar 30, 2007 6:07 am

Re: Question about the Isometric tool ...

Postby andrew » Fri Jan 11, 2013 11:24 am

Husky wrote:Any chance to get a Dimetrie Projection in QCAD what is more common in the "Engineer world".
(Ratio 0,5[x]: 1 : 1, Angle 7°/42°)


Please add a feature request at:
http://www.ribbonsoft.com/bugtracker/in ... &project=1
User avatar
andrew
Site Admin
 
Posts: 2661
Joined: Fri Mar 30, 2007 6:07 am

Re: Question about the Isometric tool ...

Postby Husky » Fri Jan 11, 2013 9:25 pm

Thanks for explanation - now it makes perfectly sense to me :D
User avatar
Husky
Moderator
 
Posts: 690
Joined: Wed May 11, 2011 9:25 am
Location: USA

Re: Question about the Isometric tool ...

Postby Husky » Fri Jan 11, 2013 9:42 pm

User avatar
Husky
Moderator
 
Posts: 690
Joined: Wed May 11, 2011 9:25 am
Location: USA


Return to Chat

Who is online

Users browsing this forum: No registered users and 3 guests