I added in the block section
dxf->writeBlock(*dw, DL_BlockData("myblock", 0, 3.0, 3.0, 0.0));
dxf->writeLine(.....);
dxf->writeCircle(.....);
....
other entities
....
dxf->writeEndBlock(*dw, "myblock");
Till this point its clear. I can see myblock in the blockmenu list in AutoCad.
But:
How can I draw this Block as an entity to a coordinate of x,y,z?? writeBlock doest work in entity section...
inserting blocks ...how?!
Moderator: andrew
inserting blocks ...how?!
Last edited by bonsalty on Wed Jun 10, 2009 10:32 am, edited 2 times in total.