OK, Version Beta 3 installed on both Windows and Linux.
Windows Bugs:
1. For some reason on the Window machine, the snap toolbar buttons are doubled for all functions. I therefore have two buttons for each type of snap and cannot access the bottom snaps unless I undoc the toolbar.
For some reason, this is still fine in the Linux Beta 3. Single buttons like always.
Issues on Both:
1. When selecting the Scissors function, it deactivates after the cut is done. One can therefore not continuously select lines and cut it at the selected point. Each time the function has to be activated from the start.
Beta 3 seems faster in opening drawings than Beta 2.
QCAD 3 BETA 3, Issues
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
I've added the appropriate reports:
http://www.ribbonsoft.com/bugtracker/in ... ask_id=331
http://www.ribbonsoft.com/bugtracker/in ... ask_id=332
http://www.ribbonsoft.com/bugtracker/in ... ask_id=331
http://www.ribbonsoft.com/bugtracker/in ... ask_id=332
Re: QCAD 3 BETA 3, Issues
@koosjr:koosjr wrote: 1. For some reason on the Window machine, the snap toolbar buttons are doubled for all functions. I therefore have two buttons for each type of snap and cannot access the bottom snaps unless I undoc the toolbar.
I have seen this behavior after the Beta3 was installed in the same (already existing) subdirectory from the Beta2.
I reinstalled the Beta3 in a new subdirectory and everything was nice working ...