Rotate Object with Unknown Angle

Use this forum to ask questions about how to do things in QCAD version 3

Moderator: andrew

Rotate Object with Unknown Angle

Postby wildspidee » Tue Jan 08, 2013 7:41 pm

I need to rotate an object to meet another object (essentially, close a gap). I don't know what the angle is to do this and there doesn't appear to be a manipulator to just drag it around.

I attached a little sample diagram to illustrate. I want to rotate A on the circled point to bring it around and be flush to B. The lines may or may not be the same length, so I can't use point to point. This diagram is greatly simplified, in the actual case the objects are much more complex, the circled point would be more in the middle and closing the gap would swing the top out and create a gap at the top.

Any suggestions? Thank you.
Attachments
Rotate.jpg
Rotate.jpg (137.88 KiB) Viewed 2329 times
wildspidee
Junior Member
 
Posts: 19
Joined: Sat Nov 03, 2012 2:00 am

Re: Rotate Object with Unknown Angle

Postby andrew » Tue Jan 08, 2013 9:03 pm

In the rotation dialog, click the button with a mouse pointer on it to define the rotation angle by mouse rather than entering a value. After clicking the OK button, you can click a reference point, then a target point. The rotation angle is the angle from (center - reference point) to (center - target point).
User avatar
andrew
Site Admin
 
Posts: 2555
Joined: Fri Mar 30, 2007 6:07 am

Re: Rotate Object with Unknown Angle

Postby J-J » Wed Jan 09, 2013 7:09 am

Thanks for this tip, I have been faced to that situation many times but I do not recall seeing that feature documented (I may have overlooked it). I always did a geometrical construction to measure my rotation angle and then apply the value in the box...

I just noticed that manual scaling can be used in the same way

JJ
User avatar
J-J
Moderator
 
Posts: 173
Joined: Tue Mar 24, 2009 9:48 pm

Re: Rotate Object with Unknown Angle

Postby andrew » Wed Jan 09, 2013 8:17 am

In the user manual it's briefly described under:
Help - Help Contents - Modify - Rotate or Scale
User avatar
andrew
Site Admin
 
Posts: 2555
Joined: Fri Mar 30, 2007 6:07 am

Re: Rotate Object with Unknown Angle

Postby wildspidee » Thu Jan 10, 2013 2:39 am

Perfect! I love this program.

I tried to look it up in the QCAD Book (Introduction to CAD). I didn't even check the regular manual. I'll make sure to look there next time.

Thank you.
wildspidee
Junior Member
 
Posts: 19
Joined: Sat Nov 03, 2012 2:00 am


Return to QCAD 3 'How Do I' Questions

Who is online

Users browsing this forum: Yahoo [Bot] and 2 guests

cron