Husky wrote:Additional question to the hatch: I can't move (etc.) a hatch with a defined (except free) snap point?
andrew wrote:The hatch needs to be prepared ...
Husky wrote:But if I have to prepare every single hatch area it will keep me busy for many hours. This is my first try with a simple design - but I have to accept that there is no way to do it on a normal, much more complicated design.
Husky wrote:The second question was based on the matter of fact that I have to prepare those hatch areas. To get rid of this task I was thinking that I just have to prepare one area and copy the hatch in similar areas without the need of preparing every area again. I separated an existing solid triangle hatch and realized that there is no way to snap just a corner of this triangle - it needs a "non hatch" reference to do that.
I've seen this feature request and yes - I think that is the only way to go!andrew wrote:A feature request exists:
http://www.ribbonsoft.com/bugtracker/in ... ask_id=763
Thanks!andrew wrote:I can see that I have introduced that limitation at one point (hatches are excluded from snapping) but I can't remember why. I will re-enable that for the next beta, unless I can figure out what the reason was.
Yes it is ...clive wrote:... is it inspired by 'The Tree of Life' by Frank Lloyd Wright ?
Thank you very much!clive wrote:Until we have a better solution this is what I do, it still involves some work but it may help!
Users browsing this forum: No registered users and 0 guests