dodaykos wrote:If I were to open the QCAD 2 .dxf files with Autodesk 2008, then the lined text comes out fine. However, if I were to create multi-lined text in QCAD 3 and open it in Autodesk, the text after the first line would not show up (The QCAD 2 text that was left untouched works just fine, though).
dodaykos wrote:Also, is there any way I could make the dashed line style to match for both versions? It's not important, but it does irk me that the dash linetype style doesn't match between the two.
Users browsing this forum: No registered users and 2 guests