FS#1130Offset Polyline from both sides at once
- Type
- Feature Request
- Status
- Assigned
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- Development
- Operating system
- All
- Reported
- 2014-11-26 by anonymous
It would be great to have a tick box to be able to offset a polyline from both sides/edges at once.
Maybe a similar feature could be added to the line -parallel tools?
Comments (1)
Offset both sides of an open Polyline/Spline is implemented under Misc .. Modify.
Depending on the indicated position there is even an semi-circle added at the ends.
The Preview for Splines may be off but the result is fine.
It seems there is only one offset for Lines-Arcs-Circles-Ellipses ...
It seems that it offsets text entities very partially ...
There may be many 'Result loop not closed' or 'No offsets possible' warnings ...
Also see: FS#2415
Regards,
CVH