FS#1364New Tool -'Run Parallel with'
- Type
- Feature Request
- Status
- Assigned
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.12.6
- Operating system
- All
- Reported
- 2016-01-28 by anonymous
- Votes
- 2
New Tool request:
When drawing a line it would be good to have a tool/option to 'run parallel with'.
For example start to draw a line and choose 'run parallel with', select appropriate line to draw parallel with!
Comments (2)
Whould be a nice feature!
I can see the benefits of this.
This might be useful to skip a Parallel Trough point and then extending and/or trimming it.
The sequence is then:
- Pick startpoint.
- Pick the appropriate line to draw parallel with.
- Indicate the endpoint as if it was a Ray.
Voted for it. ;-)
Regards,
CVH