FS#1494polyline offset fails ?
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.15.5
- Operating system
- Windows 10
- Reported
- 2016-10-20 by anonymous
- Closed
- 2016-10-20 by andrew
Hi Andrew
Exploded a spline, then created a single polyline from the segments ... but I cannot offset it, to produce another one ?
Is this a bug ?
Regards
Clive
Comments (5)
I'm unable to reproduce. What are your parameters (distance, etc.)?
To offset by 6mm
Ha, got it, sorry not using 'whole polyline'.
by the way I've sent you a private message.
OK, I'll close this report.