FS#1532Selection Problem ?
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.16.4
- Operating system
- All
- Reported
- 2017-01-19 by anonymous
- Closed
- 2017-01-19 by andrew
Please attached file. When dragging a selection window across only the cyan lines -I get only one line selected?
Comments (4)
The line at the left is 3D (i.e. at least one Z coordinate is not 0). This is currently not supported by the area selection tool.
Thanks Andrew, now I'm confused as these are lines I drew ???
You were likely snapping to one of the red lines which are also at Z = -52.5.
You might want to use Misc > Modify > Flatten Drawing to 2D to make sure all Z levels are set to 0 (unless you wish to preserve those levels of course).
No I don't need them, excellent thanks Andrew, didn't even know we had that tool!