FS#1719Undo on converted drawing leads to wrong label position.
- Type
- Bug
- Status
- Closed
- Resolution
- Won't fix
- Category
- QCAD (main)
- Severity
- Very Low
- Priority
- Very Low
- Reported version
- 3.19.2
- Operating system
- All
- Reported
- 2018-02-20 by Husky
- Closed
- 2026-10-22 by andrew
Drawing converted from inch to mm - undo leads to wrong dim label position. I can fix that with "Reset Label position" but it would be nice if QCAD could to that in first place.
Husky-2018.02.20-01.png30 KB- Dim convert undo.dxf131 KB
Comments (2)
For some reason, I cannot reproduce with any other drawing.
Please try this:
Default Template starts in mm / dimension setting decimal,
Converted to inch, changed Dimension settings from decimal to fractional,
later ... converted to mm which then shows the effect like the posted screenshot. I assume it has somewhat to do with the DIM setting "Fractional".
Another example:
Start with template in mm / decimal ... worked on the drawing,
converted to inch - still decimal,
undo .... leads again to wrong dim positioning but not that bad like the first "Fractional" example.