FS#1747Scaling w 2 ratios fails to scale polyline arc
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD (main)
- Severity
- Medium
- Priority
- Low
- Reported version
- 3.20.1
- Operating system
- All
- Reported
- 2018-04-30 by CVH
- Closed
- 2018-04-30 by andrew
Scaling without keeping the aspect ratio fails to scale an arc to an ellips when this is part of a polyline.
Discovered while documenting feature request 'Skewing'
CVH
Comments (1)
This is expected behaviour. Polylines cannot (by definition of the DXF/DWG format) contain ellipse arc segments.