FS#1845Block reference points cannot be supressed in printer output/print-preview
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.21.3
- Operating system
- All
- Reported
- 2019-01-13 by vortex_embedded
- Closed
- 2019-01-13 by andrew
Drawing preferences have no effect on point type when printed or in print-preview for block reference points.
Notice in "print output", the "Dot" (Block reference point) is displayed (drawing preferences are ignored).
See attached photos.
Main drawing point - display settings1.JPG112 KB
Block editing - reference point - display settings1.JPG108 KB
Print Preview - block reference point display settings ignored1.JPG187 KB
Print output - hairline mode - block reference point display settings ignored1.JPG66 KB
Closure comment
Intended behavior
Comments (1)
This is intended behavior. The block display preferences only affect the display, not the print. Accordingly, the point sizes are in pixels (for the screen).