FS#1949Modify > Break out: Leftover (zero length line) after using tool on ray
- Type
- Bug
- Status
- Closed
- Resolution
- Fixed
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.23.0
- Operating system
- All
- Reported
- 2019-10-01 by Krischu
- Closed
- 2019-10-01 by andrew
When using D2 on the vertical line (orange line in the attached example) a small zero length line is left over. This doesn't happen if the vertical orangle line were a finite, line with two distinct endpoints.