FS#731Break out segment: fails in some cases
- Type
- Bug
- Status
- Closed
- Resolution
- Fixed
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.0.0
- Operating system
- All
- Reported
- 2012-12-03 by andrew
- Closed
- 2014-06-18 by andrew
- Votes
- 1
See fs731.dxf
Comments (1)
I am using Linux Version 3.4.5 of QCAD.
I just experienced the same problem with "Break out Segment".
I drew two circles and then lines from A to B to C to D. (see first screenshot)
All on the same layer. One circle is coloured in green to make it easier to see the problem.
When I wanted to break out the segment of the green circle, which is outside of line BC, the result can be seen in the second screenshot.