FS#849Make maximum visible reference points of selection configurable
- Type
- Feature Request
- Status
- Assigned
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.1.4
- Operating system
- All
- Reported
- 2013-07-05 by benjamindahl
- Votes
- 1
Provide configuration option to raise / lower maximum reference points that are shown for selected entities (currently fixed to 1000).
Original report:
Imported a spline-dxf from adobe illustrator. Converted the spline to polyline with explode command. Then no anchor points / vertex points / vertices were showing anymore. Simplified the polyline so that it had less than 1000 points. Vertices became visible.
I think some freeform objects need actually more than 1000 vertices. Also them need to be edited. Please increase the amount of vertices showing to biginteger
regards
Benjamin
Comments (1)
This is a limit imposed by display performance, not data type.
I'll change this into a feature request to make this limit configurable.