QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.12.5
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 28.01.2016

FS#1363 - New Tool - make lines horizontal or vertical

New Tool Request:

To have a tool to make any given line which is ‘not’ orthogonal already into an orthogonal line.

For example if I had a line at 30 degrees by using the tool I could change the line to be either horizontal or vertical.

CVH commented on 30.10.2022 07:28

Simply a question of setting the line angle to 0-90-180-270 degrees.
Or that of a selection of line segments.

IMHO such tools are only used by a few and may saturate the GUI with unused features.

I would decline this request.

Regards,
CVH

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing