- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Windows 7
- Severity Low
- Priority Very Low
- Reported Version 3.22.1
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
FS#1918 - Splines whit control points of order 1 and 4 not selected with partially selecting cursor R>L draw
Set up a spline with control points let’s say of the order 3.
Clone it 3 times with some offset in x&y.
Edit the degree property and set 1ste to 1, 2nd to 2, aso
Draw select partially from right to left.
Those of the order 1 and 4 aren’t selected.
Regards
Closed by Andrew
06.07.2019 19:41
Reason for closing: Fixed
Additional comments about closing:
06.07.2019 19:41
Reason for closing: Fixed
Additional comments about closing:
Fixed for degree 1, out of scope for
degree 4 and higher (won't fix /
implement)
Thanks. Degree 1 splines (polylines) will be implemented / fixed for the next release.
For degree 4 and higher, unfortunately, I'm going to have to close this as "out of scope". I'm unaware of any algorithms to deal with intersections of splines of degree 4 and higher. Splines of degree 4 and higher are mostly of academic interest and mainly supported in QCAD for compatibility reasons.