Search found 7 matches

by makipsee
Tue May 21, 2019 1:02 pm
Forum: QCAD Community Edition
Topic: Fonts and positions different when reopening
Replies: 9
Views: 11604

Re: Fonts and positions different when reopening

i just tried to reset QCAD but it didnt bring back the trial. after resetting and opening the same drawing it still gives the same issue.
by makipsee
Mon May 20, 2019 9:22 pm
Forum: QCAD Community Edition
Topic: Fonts and positions different when reopening
Replies: 9
Views: 11604

Re: Fonts and positions different when reopening

i have noticed that i dont have the ability to change the font of the drawing under "Edit->Drawing Preferences->Dimension Settings" i dont have a "Dimension Label Font" section
by makipsee
Mon May 20, 2019 9:17 pm
Forum: QCAD Community Edition
Topic: Fonts and positions different when reopening
Replies: 9
Views: 11604

Re: Fonts and positions different when reopening

here are 2 screenshots. i added comments to each picture
by makipsee
Mon May 20, 2019 8:34 pm
Forum: QCAD Community Edition
Topic: Fonts and positions different when reopening
Replies: 9
Views: 11604

Re: Fonts and positions different when reopening

thank for checking it out.
Well when i opened it everything was in Tahoma as you stated. at the top right of the drawing where it says "original drawing" is it off centered? i was reading in another post and someone said i might not be able to change the fonts because i was on the community version
by makipsee
Mon May 20, 2019 7:04 pm
Forum: QCAD Community Edition
Topic: Fonts and positions different when reopening
Replies: 9
Views: 11604

Re: Fonts and positions different when reopening

Sorry for the late reply wasnt receiving emails.... haha yea thats usually my luck. i have attached a file see how this opens for you.
by makipsee
Thu May 16, 2019 9:21 pm
Forum: QCAD Community Edition
Topic: Fonts and positions different when reopening
Replies: 9
Views: 11604

Fonts and positions different when reopening

when i make a print and save it, when i go to reopen it all of the texts are different (i save them as Tahoma, when i open the print again its back to Standard). Then if i change the text height in the Dimension preferences all the fonts change back to Tahoma. also then i have a text alignment set t...
by makipsee
Thu Dec 06, 2018 2:51 pm
Forum: QCAD Troubleshooting and Problems
Topic: grid spacing
Replies: 12
Views: 13609

Re: grid spacing

Hi Caster, The answer is in 'Edit->Drawing Preferences->Dimension Settings'. You will see that the 'Dimension Label Font' box is empty. Select a font and click 'Apply', and the labels will change to metric. Hope this helps Regards riverbuoy Hi, I am currently using version 3.21.2.0 on windows 7. Wh...

Go to advanced search