Search found 3 matches

by steve_appleton
Fri Aug 16, 2019 12:40 pm
Forum: QCAD Suggestions and Feedback
Topic: Suggestion: ability to mix absolute and relative coordinates
Replies: 7
Views: 9719

Re: Suggestion: ability to mix absolute and relative coordinates

A big thank you for pointing this out to me, Husky and CVH. I had not realised this was possible. Unlike some other commands, for example LI and MV, the command "RZ" <enter> does not bring a prompt for a location or coordinates. The response is simply "Command: rz" The command line remains as "Comma...
by steve_appleton
Thu Aug 15, 2019 3:27 pm
Forum: QCAD Suggestions and Feedback
Topic: Suggestion: ability to mix absolute and relative coordinates
Replies: 7
Views: 9719

Re: Suggestion: ability to mix absolute and relative coordinates

Thank you, CVH. Indeed that is one way. However, this means that two steps must be taken instead of one. Note however that the RZ command is unfortunately a little lacking in versatility. The RZ command awaits a click on a location to snap to an intersection or snap point to set the relative zero po...
by steve_appleton
Wed Aug 14, 2019 3:42 pm
Forum: QCAD Suggestions and Feedback
Topic: Suggestion: ability to mix absolute and relative coordinates
Replies: 7
Views: 9719

Suggestion: ability to mix absolute and relative coordinates

I have recently discovered QCAD which I really like. However, I do have one suggestion that I believe will improve the software's useability - at least for me. That is to be able to mix one relative and one absolute coordinate when specifying a target point. At present the software allows the specif...

Go to advanced search