Page 1 of 1

Request - Centerline Cross Creation Tool ...

Posted: Tue Aug 13, 2013 9:15 pm
by Husky
Yes I know - I'm lazy but maybe not only me .... ;-)

It would be nice to have an "Automatic" tool to create a Centerline Cross for circles and arcs.

I could imagine to click on a tool button - click on a circle or arc - give the values for the overshoot and the orientation of the Centerline cross - and done! 8)

If somebody has already a "Centerline Cross Creation Tool" or is able to program one for QCAD it would be highly appreciated if you share this tool with the community in this forum :wink:

Definition of task:
Tool
- creates Center cross lines for circles and arcs (ellipses?),
- Line attributes dependent on active Layer,
- Option-box for overshoot setting,
- Option-box for orientation setting,
- not as a block,
Husky-2013.08.13-01.png
Husky-2013.08.13-01.png (3.87 KiB) Viewed 9265 times
I would do it by my self - but I can't program something like that ... :oops:

... can you???? 8)

Re: Request - Centerline Cross Creation Tool ...

Posted: Wed Aug 14, 2013 10:16 pm
by J-J
I second you Husky, I could use such a tool as a time saver, but I'm also nill at scripting...
JJ

Re: Request - Centerline Cross Creation Tool ...

Posted: Wed Jul 23, 2014 3:32 pm
by caigner
I just had to draw centerlines to many circles and arcs, so I support this request. Such a tool would indeed be very helpful.

Idea: The overshoot should be entered either by absolut value or in percent of diameter.