Layer logic - jams my logic or what ;)

Please use this forum to post feedback and suggestions related to QCAD.

Moderator: andrew

Post Reply
User avatar
Husky
Moderator/Drawing Help/Testing
Posts: 2434
Joined: Wed May 11, 2011 9:25 am
Location: USA

Layer logic - jams my logic or what ;)

Post by Husky » Thu Oct 18, 2018 7:23 pm

Hi,

right now I'm wondering about a layer behavior and just like to ask: Jams my logic :wink:

Scenario: I have a block, build for constructive reasons out of multiple other blocks called "Gas Lift". If I insert it on a layer (e.g. Phantom) in Model Space it will not adopt the layer attributes - yep, understandable.
If I then switch that layer to invisible the combined block will stay visible BUT I can't reach it anymore within a selection.

1. I think if I have something on a layer and switch that layer invisible everything on the layer should be invisible regardless how that block was built.
Correct?

2. A visible block which isn't reachable anymore is more than confusing and there is no easy way to check what is going on. Yes - now I know maybe an invisible layer but which one of my 25 invisible layers .... :(
If there is no other way to solve this issue then it would be nice to have at least some kind of Alert Message ...

Husky-2018.10.18-01.png
Husky-2018.10.18-01.png (19.83 KiB) Viewed 1007 times
select block issue.dxf
(127.57 KiB) Downloaded 43 times
Work smart, not hard: QCad Pro

Post Reply

Return to “QCAD Suggestions and Feedback”