[SOLVED] How to finish command line commands for a spline

[Paul D]

Hi. I tried searching the Forums, but I didn't find what I was looking for.

I'm trying to figure out how I can use the command to enter points for a a spline and then at the command-line indicate that I've entered the last point in the series. I tried "Done" but that doesn't seem to work. Is there something I can enter at the command line or do I have to do something with the mouse (would prefer not to have to use the mouse). Thank you.

Code: Select all

Command: spline
Coordinate: 0,0
Coordinate: 100,25
Coordinate: 100,50
Coordinate: 100,-75
Unknown command or invalid coordinate or value: "done"

OS: Ubuntu 22.04
Version: QCAD Professional 3.29.6 for Linux 64bit

[Husky]

Hi,
in command line:
try esc, escape or qq,
should also work in an active modelspace / GUI,
Btw - mouse would be the right mouse button, Keyboard the ESC or qq key ...

Note: If the current tool requires multiple steps, escape returns to the previous step of the tool. To terminate the tool, escape might have to be pressed multiple times in this case.

[Paul D]

Thank you!