How should I best go about hatching a drawing like the attached? I've tried Hatch From Selection but the selection process seems to drop out long before I've got all around the stairs.
Louise
Win 10 QCAD Version: 3.19.2.0 (3.19.2) Internet: QCAD.org Build Date: Dec 20 2017 Revision: 1f70332Qt Version: 5.5.1 Architecture: x86_64 Compiler:MSVC++ 12.0 (2013)
Hatching
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Re: Hatching
Hi Louise,
Nice drafting work.
Try the 'Hatch from segments' tool instead!
Regards
Clive
Nice drafting work.
Try the 'Hatch from segments' tool instead!
Regards
Clive
For the best support please state your operating system, QCAD version and add any supporting DXF/DWG files, screenshots etc...
-
- Junior Member
- Posts: 18
- Joined: Sat Dec 30, 2017 12:51 pm
Re: Hatching
But how does the tool work?Clive wrote:Hi Louise,
Nice drafting work.
Try the 'Hatch from segments' tool instead!
Regards
Clive
Louise
Re: Hatching
Essentially you would use this tool to select entities to form a boundary to hatch within, the boundary needs to be closed without any gaps at all.
For the best support please state your operating system, QCAD version and add any supporting DXF/DWG files, screenshots etc...