how do I draw tapering latitudinal lines on a globe ?

Use this forum to ask questions about how to do things in QCAD.

Moderator: andrew

Forum rules
Always indicate Operating system, QCAD version
Attach Drawing files, Screenshots
Post one question per topic.
solo
Junior Member
Posts: 10
Joined: Sat Nov 04, 2017 7:01 pm

Re: how do I draw tapering latitudinal lines on a globe ?

Post by solo » Wed Feb 07, 2018 4:01 am

The globe with the longitudinal is actually much larger and was shrunk to fit the screen , All the pairs taper to the same point at each pole , there withs and spacing is random but seen full size they smoothly taper from pole to equator to pole , the effect in full size is very eye catching .

solo
Junior Member
Posts: 10
Joined: Sat Nov 04, 2017 7:01 pm

Re: how do I draw tapering latitudinal lines on a globe ?

Post by solo » Sun Feb 11, 2018 3:23 pm

Ok so what I am getting is what I am doing is wrong and I perhaps should switch to a 3D program , The museums are full of 2D art made to look like 3D , but when I try it using a computer I am wrong , how can art be WRONG ? this is bogus .

Post Reply

Return to “QCAD 'How Do I' Questions”