QCAD.org Forum

Hi, I received a DXF but I need to separate layers to work in another application.
I need to modify the arq2.DXF file to be separated and colored layers like the arq1.dxf file

Could someone help me do this in QGIS?
Thanks a lot.

Hi,

pocorrea wrote: ↑

Tue Oct 01, 2019 8:29 pm

I need to modify the arq2.DXF file to be separated and colored layers like the arq1.dxf file

It's hard for me to believe they used only two layer for arq2.dxf. How did you load it into QCAD Trial? Menu File / Open or import? If you imported the file try instead just to open it

pocorrea wrote: ↑

Tue Oct 01, 2019 8:29 pm

Could someone help me do this in QGIS?

Probably not - this is the QCAD Forum.

Depends if Z is used.
If so, you could re-seperate by altitude in Z.
Without a file we can't even know that.

Your welcome to post both files.
Regards,
CVH