Block reference points
Posted: Mon May 18, 2020 7:49 pm
I've created a block (a square with a criss-cross in it) with a reference point in the lower left corner. I've mirrored this such that there is a gap between the two blocks. I want to measure the distance between the two blocks, but, there are no reference points other than in the one corner. And I can't snap to those reference points. Is there a way to snap to these corners or other control points of the block elements? I could explode the block, but that defeats the purpose of using blocks. See the attached drawing.
Windows 8, QCAD 3.24.3.0
Windows 8, QCAD 3.24.3.0