Strange behavior when adding a simple angular dimension between two lines.
Command:dimangular shows in Command window, but there are no prompts displayed to select first line or second line.
If I proceed and select the first , then second, the Dimension Arc Location: prompt appears and the dimension is properly added.
QCAD3 RC2 Issue adding angular dimension
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
-
- Full Member
- Posts: 58
- Joined: Thu Oct 13, 2011 7:38 pm
Moved to bug tracker:
http://www.ribbonsoft.com/bugtracker/in ... ask_id=411
http://www.ribbonsoft.com/bugtracker/in ... ask_id=411
-
- Full Member
- Posts: 58
- Joined: Thu Oct 13, 2011 7:38 pm
-
- Full Member
- Posts: 58
- Joined: Thu Oct 13, 2011 7:38 pm
Here is an additional observation that "feels" like the same issue:
I was adding an orthogonal line to and existing line.
The lineorthogonal command appears in the comand window, but the prompts to "select line" do not appear and the menubar (left of work area) does not switch context to the display of "where on the line to put it" e.g. grid, on-entity, endpoint, etc ( I forget the proper terminology).
As before, the "where to put it" is in Auto mode and the orthogonal line does place properly.
I was adding an orthogonal line to and existing line.
The lineorthogonal command appears in the comand window, but the prompts to "select line" do not appear and the menubar (left of work area) does not switch context to the display of "where on the line to put it" e.g. grid, on-entity, endpoint, etc ( I forget the proper terminology).
As before, the "where to put it" is in Auto mode and the orthogonal line does place properly.