I thought I would share this laser cut file for a card stock lantern, quite simply just cut out the four sides, glue together and job done. I guess for the very skilled you could use a craft knife (be careful).
laser cut 'Lantern' file
Moderator: andrew
-
Clive
- Moderator
- Posts: 1251
- Joined: Thu Aug 25, 2011 9:28 pm
- Location: UK
laser cut 'Lantern' file
Hi guys
I thought I would share this laser cut file for a card stock lantern, quite simply just cut out the four sides, glue together and job done. I guess for the very skilled you could use a craft knife (be careful).
I thought I would share this laser cut file for a card stock lantern, quite simply just cut out the four sides, glue together and job done. I guess for the very skilled you could use a craft knife (be careful).
- Attachments
-
- lantern .dxf
- (1.05 MiB) Downloaded 2328 times
-
- lantern.png (45.12 KiB) Viewed 81114 times