Toolpath dialog won't remember Lead In Type when Side/Direction set to "On".
It works as expected when Side is Outside or Inside.
Minor bug (cam 3.17)
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Re: Minor bug (cam 3.17)
Thanks for your report.
Lead in / out are actually not supported if the toolpath is generated on the profile. For this reason, lead in / out are reset to None when side is changed to On.
I can probably provide more information if you can ellaborate on what you are trying to achieve with this setting.
Lead in / out are actually not supported if the toolpath is generated on the profile. For this reason, lead in / out are reset to None when side is changed to On.
I can probably provide more information if you can ellaborate on what you are trying to achieve with this setting.
Re: Minor bug (cam 3.17)
I was just trying things. If it's not supported, is it a bug that qcad added the path??