I've noticed if I update the plunge rate for a cam tool it doesn't dynamically update toolpaths which are using the same tool - in this example T1.
I had to go through and update more than 20 toolpaths manually - should this be the case or am I missing something here?
Updating plunge rate
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Updating plunge rate
For the best support please state your operating system, QCAD version and add any supporting DXF/DWG files, screenshots etc...