thank you very much for the new version. The option to set taps is very helpfull. Great work!
I think you are intrested in a bug since that version (I'm not shure, maybe the version before).
1. load a file
2. close the file
3. load the same file again
4. click CAM Configuration -> 100% CPU -> kill -9
A click on CAM Configuration when opened first time works.
I use the Linux Version with leap 42.3 all updates.
The file used is attached.
If you nee more information, no problem.
Discussions around the CAM Add-On of QCAD.
1 post • Page 1 of 1