impact radius of tabs

Discussions around the CAM Add-On of QCAD.

Moderator: andrew

Post Reply
cki61
Junior Member
Posts: 18
Joined: Fri Jan 19, 2018 5:43 pm

impact radius of tabs

Post by cki61 » Mon Apr 30, 2018 5:43 pm

Hi Andrew,

I experimented a little bit with tabs. Everything is ok when using tabs at pieces with great distance between lines (I don't know which one).
Smaller work pieces (I attached my test object) have problems. The two tabs at the outer line are as well influencing the two inner lines.
Did I misunderstood the use of tabs?

Best Regards,
Christof

to my todays new example:
Screenshot_20180501_120317.png
Screenshot_20180501_120317.png (6.94 KiB) Viewed 1039 times
Right side: tab on line -> inner line impacted -> NOT OK
Left side: tab beside line -> inner line NOT impacted -> OK
Hint: I don't know why the tab in the middle of the lower line doesn't impact the inner line!?
So: the impact area is not a radius but something like a rectangle I assume.

see 3D-View below:
Screenshot_20180501_120236.png
Screenshot_20180501_120236.png (7.12 KiB) Viewed 1039 times
Attachments
Fassung MPX _1Buchse.dxf
(161.34 KiB) Downloaded 46 times

Post Reply

Return to “QCAD/CAM”