Page 1 of 1
(solved) Circle (Tangent-Tangent-Radius) not working
Posted: Mon Jun 29, 2015 8:36 pm
by jvalencia
I don't know what I'm doing wrong, but it just doesnt work.
It works with Tangent-Tangent-Point, but that's not desirable in this case. I want a radius of 2 mm.
This is what I want to achieve (red circle):
I'm using Qcad 3.9.4 CE.
See my attached dxf, please.
Re: Circle (Tangent-Tangent-Radius) not working in this case
Posted: Mon Jun 29, 2015 8:47 pm
by andrew
This seems to work fine here. Perhaps you're trying to draw on a locked layer.
Re: Circle (Tangent-Tangent-Radius) not working in this case
Posted: Mon Jun 29, 2015 9:04 pm
by jvalencia
andrew wrote:This seems to work fine here. Perhaps you're trying to draw on a locked layer.
Hi Andrew, I just get a "No Solution" error in the command line.
I click one arc, then the other and finally I get a "No solution" message.
Re: Circle (Tangent-Tangent-Radius) not working in this case
Posted: Mon Jun 29, 2015 10:24 pm
by Clive
Hi', you need to make sure that you enter the radius 2 in the upper field box.
Re: Circle (Tangent-Tangent-Radius) not working in this case
Posted: Mon Jun 29, 2015 10:45 pm
by jvalencia
Clive wrote:Hi', you need to make sure that you enter the radius 2 in the upper field box.
Hi Clive, you were right. I'm still paying the autocad toll. I was expecting a radius input in the command line.
By the way, this software rocks!