Which finger am I having problems with?
Snap
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
-
Graham Wright
- Junior Member
- Posts: 16
- Joined: Tue Oct 01, 2013 11:00 am
Snap
I am recommended to snap to grid in the foreword. After a few drawings, I find this generally very helpful. However, I seem to run into problem with setting the grid. I understand there are two lots of preferences and have been using the edit one. I seem to be stuck with a 1mm grid even though requesting 0.1 etc. I have set the minimum grid lower in main preferences.
Which finger am I having problems with?
Which finger am I having problems with?
-
Graham Wright
- Junior Member
- Posts: 16
- Joined: Tue Oct 01, 2013 11:00 am
Re: Snap
Please point me to it. (I am a novice!)
Re: Snap
If you need help with attaching files to a forum post, please refer to:
viewtopic.php?f=47&t=3760
viewtopic.php?f=47&t=3760
-
Graham Wright
- Junior Member
- Posts: 16
- Joined: Tue Oct 01, 2013 11:00 am
Re: Snap
Please confirm receipt.
-
Graham Wright
- Junior Member
- Posts: 16
- Joined: Tue Oct 01, 2013 11:00 am
Re: Snap
Think that's it.https://www.qcad.org/rsforum/download/f ... ew&id=5110
- Attachments
-
- Boat Electrical System pdf.pdf
- (209.63 KiB) Downloaded 717 times
Re: Snap
Thanks for the pdf but we need the dxf or dwg to look into it. Please attach the dxf / dwg to this post.
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."