Cutting off lines after radiusing
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Cutting off lines after radiusing
This may have been covered, and I may not have a good description but could not find an answer. In older versions, If I drew a square, then radiused the corners, the straight lines went away, in the current version the straight lines remain, and I break out the segments. Curious if there is a setting to change this. Thanks.
Re: Cutting off lines after radiusing
Please refer to the user manual at:
https://qcad.org/doc/qcad/latest/refere ... c/RoundPro
Check "Trim" if you want to trim the entities automatically. If the option is disabled, the two corner entities will remain untouched.
https://qcad.org/doc/qcad/latest/refere ... c/RoundPro
Check "Trim" if you want to trim the entities automatically. If the option is disabled, the two corner entities will remain untouched.