I'm using 2.2.1.0 and copy and paste between drawings does not have the choice of which snap I would like to use. I need the accuracy between drawings. Is there a way to change this or am I committed with this as default?
Jim
Copy and paste between drawings
Moderator: andrew
-
- Newbie Member
- Posts: 9
- Joined: Sun Apr 08, 2007 7:55 am
- Location: Mesa Arizona USA
Please refer to this thread:
http://www.ribbonsoft.com/rsforum/viewtopic.php?t=382
Or question 4 in our FAQ:
http://www.ribbonsoft.com/qcad_doc_faq.html#4
http://www.ribbonsoft.com/rsforum/viewtopic.php?t=382
Or question 4 in our FAQ:
http://www.ribbonsoft.com/qcad_doc_faq.html#4
Last edited by andrew on Mon Dec 14, 2009 4:06 pm, edited 1 time in total.
-
- Newbie Member
- Posts: 9
- Joined: Sun Apr 08, 2007 7:55 am
- Location: Mesa Arizona USA
I was searching the forums and found the answer. Of course it was right in front of me.
http://www.ribbonsoft.com/rsforum/viewtopic.php?t=382
Jim
http://www.ribbonsoft.com/rsforum/viewtopic.php?t=382
Jim
-
- Newbie Member
- Posts: 9
- Joined: Sun Apr 08, 2007 7:55 am
- Location: Mesa Arizona USA