CAM Tool lists

If you are having problems with QCAD, post here. Please report bugs through our Bug Tracker instead.

Always attach your original DXF or DWG file and mentions your QCAD version and the platform you are on.

Moderator: andrew

Forum rules
Always indicate Operating system, QCAD version
Attach Drawing files, Screenshots
Post Reply
Newbie Member
Posts: 6
Joined: Wed Nov 17, 2010 5:48 am

CAM Tool lists

Post by mthomas » Sat Jun 01, 2019 9:09 pm

It would be very convenient if when defining a tool (mill or drill) you could define a zstep rate matched to the tool for the intended material. These tool sets could then be exported, as an example to a series of tool definition files;


It would be then quite simple to then import whichever set is appropriate to the material being used. The key here (and this ties to my previous posting on drill and mill pecking calculations. The key being a field where the zstep rate could be defined per tool;

Post Reply

Return to “QCAD Troubleshooting and Problems”