Fusionner des entités
Fusionner des entités
Est-il possible de fusionner 2 entités (exemple 2 segment de droite en un seul segment de droite ?
Re: Fusionner des entités
Non, mais vous pouvez le convertir en polyligne.
Work smart, not hard: QCad Pro
If a thread is considered as "solved" please change the title of the first post to "[solved] Title...". Thanks!
If a thread is considered as "solved" please change the title of the first post to "[solved] Title...". Thanks!
Re: Fusionner des entités
En plus,
polyligne simplifient peuvent joindre des segments,
Explode renvoie les segments joints comme un seul.
(What a bad translation)
Cordialement,
CVH
polyligne simplifient peuvent joindre des segments,
Explode renvoie les segments joints comme un seul.
(What a bad translation)
Cordialement,
CVH
QCADpro 3.25.2.7 / win7pro 32 bit / 4GB / 1e generation i7 2.6Ghz / HDD GeForce GT 520
-
- Newbie Member
- Posts: 3
- Joined: Fri May 29, 2020 8:06 pm
Re: Fusionner des entités
No problem with the translation, it's perfectly understandable, thanks!