Outer contour generation seems impossible for this simple object (attached). Redrew it at least 10 times to make sure the lines all connect, turned around to see if it would work better, gave up after about an hour of trying. What is wrong here? Still incorrect connected lines?
Thanks for help,
Robert
[Solved] Contour generation fails
Moderator: andrew
[Solved] Contour generation fails
- Attachments
-
- test27.dwg
- (29.93 KiB) Downloaded 62 times
Last edited by RobB on Sun Jun 14, 2020 8:47 am, edited 1 time in total.
Linux Mint 20 , qcadcam-3.24.3.10-pro-linux-x86_64
Re: Contour generation fails
Nope - duplicates ...

You may doublecheck the big (R33) radii ...
Work smart, not hard: QCad Pro
If a thread is considered as "solved" please change the title of the first post to "[solved] Title...". Thanks!
If a thread is considered as "solved" please change the title of the first post to "[solved] Title...". Thanks!
Re: [Solved] Contour generation fails
Thanks...
Robert
Robert
Linux Mint 20 , qcadcam-3.24.3.10-pro-linux-x86_64