Applying parameters of measures in behind?
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
-
Krischu
- Premier Member
- Posts: 191
- Joined: Thu Jul 04, 2019 8:11 am
Applying parameters of measures in behind?
Assumed I have applied a measure and have finalized it in the drawing. It's an angled measure but by chance I forgot to apply an angle, say -45°. Can I select the measure and apply the -45° afterwards? Or change the prefix in behind? Looks like I can change the prefix and text, but when I change the dimension angle the measured dimension gets distorted.
--
Christoph
Christoph
-
CVH
- Premier Member
- Posts: 5136
- Joined: Wed Sep 27, 2017 4:17 pm
Re: Applying parameters of measures in behind?
Hi,
For placed as by default that should not happen.
When re-arranged then a change to its properties, position or whatever may revert to default placement.
Perhaps default placement is what you call distorted.
Otherwise an example would be handy.
Regards,
CVH
For placed as by default that should not happen.
When re-arranged then a change to its properties, position or whatever may revert to default placement.
Perhaps default placement is what you call distorted.
Otherwise an example would be handy.
Regards,
CVH