- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD/CAM
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Low
- Reported Version 3.30.1
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Andrew - 10.07.2024
Last edited by Andrew - 10.07.2024
Opened by Andrew - 10.07.2024
Last edited by Andrew - 10.07.2024
FS#2584 - CAM Export: Wrong start point for lead in/out when outputting offset path with start point in arc
See also:
https://www.qcad.org/rsforum/viewtopic.php?f=74&t=10951
The start point of the lead in / end point of the lead out is wrong when using a post processor with:
this.outputOffsetPath = true;
This can lead to overcuts when starting a contour inside an arc segment.
Same issue as reported in:
https://www.qcad.org/rsforum/viewtopic.php?f=74&t=10724#p44206 https://qcad.org/bugtracker/index.php?do=details&task_id=2558
It is not limited to entries at arcs.
Regards,
CVH