QCAD Bugtracker

  • Status Closed
  • Percent Complete
    100%
  • Task Type Bug Report
  • Category QCAD/CAM
  • Assigned To
    andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.31.1
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 1
    • CVH (26.10.2024)
  • Private
Attached to Project: QCAD Bugtracker
Opened by Schoggi - 25.10.2024
Last edited by andrew - 28.10.2024

FS#2609 - CAM > Nesting: margin to islands not kept

Nesting places objects on sheet with islands too close to the island.
The margin is about the half of the “Margin” parameter used between objects.
I would assume to use the full “Margin” parameter distance or even the “Sheet Margin” parameter value.

macOS: 15.0.1

   NestingWithIslandTest.dxf (186.2 KiB)
Closed by  andrew
28.10.2024 07:03
Reason for closing:  Fixed
CVH commented on 26.10.2024 10:33

The margin is about the half of the “Margin” parameter used between objects.

The minimal margin between objects is apparently not a fixed value throughout.
The margin with the sheet island is more stable and is about 1 unit.

Agreed, the distance to use here should be the sheet margin.

Voted it up. I would however degrade 'Severity' because it doesn't affect many users or crash the system.

Regards,
CVH

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing